This time, I will be assembling one of the more fiddly models in the Star Legion line, the Lionheart /A. To start, grab some super glue, flush cutters, and a file.
Using flat end of the cutters, carefully cut the accessory pieces from the sprue. if the parts near the middle are hard to reach, go ahead and snip the sprue in half.
Use your file to smooth out the rough edges left by the sprue and mold lines. This is mostly aesthetic, so go into as much detail as you like.
You might find that the side panels are bent. You should be able to gently straighten them out with your fingers
Attach the track guards, with a drop or two of glue on top of the tracks.
I find it easiest to attach the turret side armor be holding the turret sideways and dropping the piece onto a drop of glue.
The same strategy works for the sponson guns if you decide to add them. Put a drop of glue on the square attachment point and nudge the gun into place.
You can add a 1/16 x 1/32 magnet to the top and bottom slots of the turret, but for now, the Lionheart is ready for the paint shop!